Schlage BE469NX User's Guide Bedienungsanleitung

Touchscreen Deadbolt with Alarm User’s Guide

10ENGLISHMY CODESUse these tables to record Programming and User Codes that you program into the lock.• The Programming Code can be any combination o

11ENGLISHMY CODESDATE PROGRAMMING CODEUSER NAME USER CODEExample: John Smith 12341. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15.

12ENGLISHFACTORY DEFAULT RESETWhen should you perform a Factory Default Reset?• When you want to move the lock to a different door.• If you have for

13ENGLISHFACTORY DEFAULT RESETThe lock must be set up again after the reset is complete:1. Open the door if it is not already open.2. Press the Outsid

14ENGLISHPROBLEM SOUNDS LIGHTS SOLUTIONI forgot my Programming Code.— — Check the back of this guide or the back of the Alarm Assembly for default Pro

15ENGLISHPROBLEM SOUNDS LIGHTS SOLUTIONAfter entering a User Code to unlock the lock, the yellow dot is ashing and there is a delay before unlock.Sev

© 2012 Ingersoll RandAll rights reserved. 24060857 Rev. 11/12-b*24060857*24060857Ingersoll Rand (NYSE:IR) advances the quality of life by creating and

2ENGLISHCONTENTSWarranty and FCC/IC Statements ... 3Lock Setup ... 3Lock Parts ...

3ENGLISH PLEASE KEEP THIS GUIDE This guide contains important information about your lock! • Default User Codes and Programming Code are located on t

4ENGLISHLOCK PARTSDOOR INTERIORAlarmDOOR EXTERIORTouchscreenOutside Schlage ButtonTouchscreenCylinderAlarm SpeakerInside Schlage ButtonThumbturnBoltIn

5ENGLISHLOCKING AND UNLOCKING L If you make a mistake while entering a User Code, press the Outside Schlage Button and start again.Locking from the Ou

6ENGLISHTips for Successful Programming L Want to see a video of programming before you begin? Browse to answers.schlage.com. L The lock comes preset

7ENGLISHProgramming Procedures L Extend the deadbolt before beginning. L Determine how long you want your User Codes to be BEFORE adding any User Code

8ENGLISHPowering the AlarmThe alarm is turned off by default. After installation, you’ll need to turn on your alarm. L Program the alarm using the Ins

9ENGLISHChanging the Alarm ModeAfter you power on the alarm, it will be preset to the Forced Entry mode, by default. If you want to change the mode, f